Featured
- Get link
- X
- Other Apps
I-Wifi01 Installation Instructions
I-Wifi01 Installation Instructions. Powered, connected and installed internally, the wifi adapter eliminates the need to run an ethernet cable to a local network router. 5 operation instruction 6 instructions on how to use pogme 7 using “pogme” 8 accessories 9 specification 10 documents / resources.

Installation and service must be performed by a licensed professional hvac installer (or equivalent) or service agency. Configure the ip settings configure the panel’s ip settings: Take pictures of visitors on your phone.
Wifi Repeater Quick Installation Guide.
The user shall not make any changes or modifications to the equipment unless authorized by the installation instructions or user's manual. Installation and service must be performed by a licensed professional hvac installer (or equivalent) or service agency. Powered, connected and installed internally, the wifi adapter eliminates the need to run an ethernet cable to a local network router.
Wifi01 Submodule Wifi01 Is A Submodule Which Plugs In To Ucm06, Cm9001.
Android users press back button to run in “background” modeor “close app” to save battery. Warning this is a 24vac class 2 thermostat. Momentary press gate/door release 2.
Contact Us Via Web Form By Clicking The Link Above, Or Call Us:
Discuss with the owner of the network whether to assign a fixed ip address to the panel, or to allow it to obtain an ip address from a dhcp server. Ios and android versions of the app are noted in these instructions. +44 2081441817 [email protected] international shipping.
Setup Instructions, Pairing Guide, And How To Reset.
You have no items in. It has been tested and found to comply. 4.1 wall mounted position if you want to place the device attached to the wall, please consider any of the three options
Take Pictures Of Visitors On Your Phone.
Turn off pogme before installing authentic cushions produced by 10pple. Cause interference to radio communications. If the wifi01 has been purchased separately, remove the cm9001 or ucm06 from the enclosure and screw in the 2 standoffs withnuts from the back of the cm9001 or ucn06 pcb so that wifi01 can be plugged in on top of the pcb.
Comments
Post a Comment